Mobotix D12 Technické informace stáhnout pdf (Strana 53)

3.3.6 Camera Startup Sequence

As soon as the power supply is established, the camera's LEDs will provide informati-

on on the startup sequence of the camera.

• Booting: Immediately after connecting the power supply, the red LED lights

up, blinks for two seconds, then stays on permanently. The camera's boot

loader checks the hardware, unpacks and starts the operating system. All ap-

plications are verified using the checksums; in case of an error, the camera will

start using the backup operating system.

• Waiting for key pressed: Both LEDs light up for four seconds. If you press the

"R" or "L" key of the camera during this time, the camera will execute the

corresponding function (see sections 3.5 and 3.6).

• Ready: Once the application software has been started, the green LED is on

permanently and the red LED blinks. You can now reach the camera via the net-

work using a browser. For additional information on this topic, see section

5.4.3,

LED Signals and LED Configuration

, in the

Software Manual

www.mobotix.com • [email protected]

51/76

M22M Camera Manual Part 1

Start!

Key?

Ready

Note

During the startup sequence or a software reboot, the LEDs will always

light up, even if they have been deactivated in Admin Menu > LED

Setup.

Note

If you are using Power over Ethernet components (IEEE 802.3af) for

supplying power to the MOBOTIX M22M, these components have to

provide PoE class 0 (12.95Watts max. power consumption of attached

device). Although the M22M only uses 3Watts and does not require

heating even at very low temperatures, this will ensure that devices

attached to the USB port of the camera will be properly supplied.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 81 82

Žádné komentáře

Mobotix D12 Technické informace Strana 53