Mobotix D12 Technické informace stáhnout pdf (Strana 34)

2.7.7 Mounting the Pole Mount and the Camera

Use the supplied stainless steel straps (item2.5) for affixing the pole mount to the

pole.

•Guide the connector cables of the camera

from behind through the opening at the cen-

ter of the pole mount. In order to properly

protect the cabling, you should let the cab-

ling run from the inside of the pole through

the pole mount directly into the camera.

Note: The cable to the camera should be

running at least 50cm (20") outside of the

pole!

• Guide the stainless steel straps (item2.5)

through the pole mount (see figure). The

stainless steel straps allow attaching the

mount to poles with diameters between 60

and 180mm (2.4" to 7.1").

• Firmly tighten the screws of the stainless

steel straps.

• Unscrew the upper Allen screw in the foot of

the mount, which holds the turn/tilt unit in

place (5mm Allen wrench, item1.3). Remove

the Allen screw, washer and hex nut from the

mount and pull the turn/tilt unit out of the

mount's foot.

www.mobotix.com • [email protected]

32/76

M22M Camera Manual Part 1

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 81 82

Žádné komentáře

Mobotix D12 Technické informace Strana 34