Mobotix D12 Technické informace stáhnout pdf (Strana 35)

• Remove any installed connection cables and

guide the connection cables through the foot of

the mount and the turn/tilt unit of the SecureFlex

mount. Hook up the cables to the camera con-

nectors, as described in section 3.3,

Connec-

ting the Camera to the Network and the Power

Supply

Make sure

that you use

the proper

plugs (NET for

Ethernet, USB

for the USB

cable)!

Also take care not to bend the cables too much as they enter the plugs

or water may enter the camera!

• Re-install the turn/tilt unit of the SecureFlex

mount and lightly tighten all screws of the turn/

tilt unit so you can easily find the best camera

position later on.

• Use the supplied screws M6x25mm (item2.3),

washers dia. 6.4mm (item2.2) and hex nuts

M6 (item2.4) to attach the foot of the mount

(including the camera) to the pole mount.

• Properly position the camera and then tighten

all screws of the turn/tilt unit (max. 4Nm/2.95

lbf ft) to make sure that the camera keeps its

position.

• Press the white caps (item1.10) onto the hex

heads of the screws.

www.mobotix.com • [email protected]

33/76

M22M Camera Manual Part 1

Maximum torque for all

Allen screws: 4Nm

(2.95lbf ft)

Maximum torque for hex

head screws: 4Nm

(2.95lbf ft)

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 81 82

Žádné komentáře

Mobotix D12 Technické informace Strana 35