Mobotix D12 Technické informace stáhnout pdf (Strana 38)

2.8.2 Mounting to a Drywall

Use the supplied materials and suitable tools for mounting the SecureFlex mount to

a drywall. Follow the

Mounting Instructions

below to complete the installation.

Required Materials:

• 4 hex head screws (item1.6)

• 4 washers (item1.5)

• 4 dowels (item1.4)

Required Tools:

• Power drill

• Suitable drill bit

• Hammer (optional)

• Wrench or ratchet for M6 hex heads

• Allen wrench 5mm (item1.3)

Mounting Instructions:

• Hold the drilling template at the position where you would like to mount the

camera.

• Mark the holes for drilling with a pencil or a sharp object, then remove the

drilling template.

• Drill the holes with the power drill where you just marked.

• Insert a dowel into each of the holes you just drilled. If required, use the

hammer to press the dowels into the holes.

• Slide a washer (item1.5) over every hex head screw (item1.6).

• Hold the SecureFlex mount against the wall. Make sure that the openings in

the mount's foot line up with the dowels.

• Insert the four screws (with washers) into the openings in the foot of the

SecureFlex mount and into the dowels.

• Tighten the screws using the wrench or ratchet.

• Check the screws for proper tightness and push the caps onto the hex

heads.

www.mobotix.com • [email protected]

36/76

M22M Camera Manual Part 1

Find the drilling template

at the end of the manual

Maximum torque for hex

head screws: 4Nm

(2.95lbf ft)

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 81 82

Žádné komentáře

Mobotix D12 Technické informace Strana 38