Mobotix D12 Technické informace stáhnout pdf (Strana 36)

2.8 Mounting the Camera to Different Surfaces

www.mobotix.com • [email protected]

34/76

M22M Camera Manual Part 1

Notes

Above-the-wall assembly:

When installing an above-the-wall assembly instead of using a wall

outlet, you can break out one of the four cable openings in the foot of

the mount to properly guide the cable into the mount.

Mounting the camera outdoors:

When using a wall outlet for an outdoors installation, you should

use silicone sealant to prevent water from entering the wall outlet and

the cabling by sealing off the mount's foot against the wall. You should

break out the lower cable opening in the mount's base to prevent con-

densation from accumulating. Make sure not to seal off this opening.

When using an above-the-wall assembly, make sure that you install

the cable from the bottom-most cable opening in order to prevent

rainwater from entering the mount. When using an above-the-wall

assembly, sealing off the SecureFlex mount and the wall is not absolu-

tely necessary. Make sure that condensation can exit the mount

despite the above-the-wall assembly. Make sure not to seal off this

opening.

Wall thickness:

Make sure that the wall is at least five centimeters (2") thick if you

intend to use the supplied dowels and screws.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 81 82

Žádné komentáře

Mobotix D12 Technické informace Strana 36