
2.7 Mounting the MOBOTIX M22M to a Wall or Ceiling
The wall mount is large enough to mount the camera over a wall outlet (see section
2.7.4,
Mounting the Camera over Wall Outlets
).
In order to increase the tilt of the camera, turn the vertical tilt joint by 180 degrees or
shorten it.
2.7.1 Mounting to a Wall
Before attempting to mount the camera,
make sure that you have found the best
camera position. It is important that the
camera's field of view is not obstructed in
any way.
Once the camera has been mounted to
the wall, you can fine-tune its position.
Using the integrated SecureFlex wall
mount, the camera can be turned hori-
zontally and tilted vertically.
When mounted to a wall, the camera
can be turned/tilted as follows:
• horizontally: approx. 180°
• vertically: approx. 70°
2.7.2 Mounting to the Ceiling
Before attempting to mount the camera
to a ceiling, make sure that you have
found the best camera position. It is
important that the camera's field of view
is not obstructed in any way.
Once the camera has been mounted to
the ceiling, you can fine-tune its position.
Using the integrated SecureFlex wall
mount, the camera can be turned hori-
zontally and tilted vertically.
When mounted to a ceiling, the camera
can be turned/tilted as follows:
• horizontally: 360°
• vertically: approx 90°
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
28/76
M22M Camera Manual Part 1
Maximum torque for hex
head screws: 4Nm
(2.95lbf ft)
The mount covers RJ45
wall outlets and conceals
the cabling
Always use the NET plug
for the Ethernet and the
USB plug for the USB
cable
Make sure that the plugs
are firmly seated and
that the cables are not
bent within the plugs as
water may enter into the
camera
Caution
Never use screws with countersunk heads to fasten the mount, as
these screws will destroy the mount.
Komentáře k této Příručce